![]() Went to settings in FORScan and tried each of the connection types and in the MS-CAN Support box have "HS/MS switch" entered. Ran everything over again and am still getting the same message.Ħ. ![]() I uninstalled and reinstalled FORScan and Crossover (purchased license this time).ĥ. ![]() ![]() Check connection." I tried it again with your suggestion of re-unchecking demo box and I am still getting the No adapter found error message.ġ. I initially had the demo box unchecked but was getting a "No adapter found. Change Maximum response time parameter from 300 to 1000 ms. Change COM port from Auto to COM1 (or whatever you set up in item #2 above) Change connection type from Auto to COM Install FORScan, run it, go to FORScan settings ando do the following changes: In order to fix it, you need to run the following command in terminal:Ĥ. Latest version of OSX allow access serial devices only to root. Map your USB device from MacOSX space to CrossOver space, here is the tutorial:ģ. You may use this tutorial to identify your USB to UART chip:Ģ. Different chip require different drivers: Install native MAC OS X drivers for the USB-UART chip in your adapter. If you need instruction on how to install CrossOver, please check this thread: viewtopic.php?f=4&t=7339ġ. This article is about driver installation only.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |